Ringwood, John and Grimble, M.J. (1986) Shape control in Sendzimir mills using both crown and intermediate roll actuators. In: 25th IEEE Conference on Decision and Control, 1986. IEEE, pp. 724-729.

Preview

Download (368kB) | Preview

Abstract

The solution to the shape control problem for a Sendzimir mill, utilising the As-U-Roll shape actuators, is well understood. The tapered first intermediate rolls, however, provide a more powerful shape control device. This paper describes a control philosophy utilising both the As-U-Rolls and first intermediate rolls as shape control mechanisms. A robustness result for the design is developed, which is useful, since such a mill is normally used to roll a large number of materials, and a single controller must therefore be employed for many different schedules. Finally, a variety of simulation results are presented, showing the transient responses and performance of the multivariable shape control system.

Item Type:	Book Section
Keywords:	Shape control; Milling machines; Actuators; Industrial electronics; Bills of materials; Control engineering education; Industrial control;
Academic Unit:	Faculty of Science and Engineering > Electronic Engineering
Item ID:	9570
Identification Number:	https://doi.org/10.1109/CDC.1986.267451
Depositing User:	Professor John Ringwood
Date Deposited:	19 Jun 2018 15:36
Publisher:	IEEE
Refereed:	Yes
URI:
Use Licence:	This item is available under a Creative Commons Attribution Non Commercial Share Alike Licence (CC BY-NC-SA). Details of this licence are available here

Repository Staff Only(login required)

Item control page

Downloads

Origin of downloads